Articles in "3D Capturing" Category

The size of RS232 9 Pin connector is 30.80" W x 12.50 H 

How to Link EzScanner in EzDent-i - or if the 'Scanner' button is not found in EzDent-i Aquisition tab is not found. First verify that the veresion 3.2.5 or higher is installed Verify that the EzScanner software is installed by checking C:\Program Files\EzScan-i is present. Open EzDent-i Under 'Aquisition' , go to the 'Console P...

Download and install EzEval Tool & Manual. EzEval software will self-guide you through each step by clicking 'Next' to insure the platters are loaded properly.Download the EzEval Tool and Manuals  Following the installation manual. Use this guide as a reference in conjunction with the downloaded guide for checking. Extract the...

First Generation Pax-i3D Smarts serial number 061~XXXX (Black Color)DOES NOT offer Stone model scanning. Second Geneeration Pax-i3D Smarts serials number 069-XXX (White Color)DOES offer Stone Models Scanning.

Regulatory documents can be found by choosing the product name below that matches your unit.       The following types of documents can be found are: X-Ray Dose & DAP Reports Scatter report & Leakage Reports Accaptance reports by model. Pax-i SeriesPax-i Paxi-3D Pax-i InsightPax-i3D SmartPax-i3D Smart RCPax-i3D...

Vatech Recommends your dealer technician access the following link to download the general PM schedule. Preventive Maintenance Schedule.PDF

In the even that VTFileManager is not running at the time of saving and fails; you might get a balloon message that VTFilemanager does not work; and also unsaved images exist.Once you have solved the VTFilemanager connection issue you can follow the next steps to re-send the image for saving. If not please see -  Locate the task tray located n...

When trying to take images 2d Panoramic/Ceph or 3D CT images - Capture program produces "Error Code 11" or "Error Code 30" as shown below. In some cases you might get a blank empty box appear having only image of a Red XError [Code:11] / Error [Code:30] will also appear as shown below  In some cases; an Empty Box - Hav...

Please note the following procedure applies to All Pax-i, Paxi3D, Paxi3D Green , Smart3D  units and some other  P1 Equipped units that use "NCSW" (New Capture Soft Ware) as show below in the screen shots.The procedure for re-saving for all modalities; Pano, Ceph, CT are all basically the same except the mode we pick, also if you...

The most common reason for E009 or E020.030.000 is the emergency stop switch. Locate the emergency stop switch located typically under the "Handle frame" this is the part of the arm that sticks out for patient to hold onto and supports the chin rest.Rotate the switch in the direction indicated by the arrows; if engaged typically it will 'pop' out when you turn it in the direction of the arrows and the unit will turn on.